Reply To: 1964 Evinrude 28HP control box

[bob-d]

Don, the fellow that installed, the botched job way back when did however install a kill switch at the dash.
So I’m good there.
The only wiring info that I’ll use from the old diagram is where to pick up the power and wiring direction for the choke switch, since the start switch and kill switch were wired properly.
So the final finished product will be a push start switch, push choke, and a kill switch at the dash.
I also was lucky enough to find a complete choke assembly off a 1964 28HP !!
Dan Gano (great guy) was nice enough to go through his boxes of old carbs and found a good used unit.
Thanks,
Bob D