Home › Forum › Ask A Member › Gear Case too tight after assembly › Re: Gear Case too tight after assembly
December 31, 2015 at 2:24 am
#29429
Me two Pappy,
Something is out of alignment. Remove the propshaft & look at the bearing supports that cradle the shaft. It should have a small hole in the bearing carrier. Next find the pin in the case & hope you haven’t pushed it in to the case as the pin fits the carrier to secure it.
P.S. NEVER assemble anything that dry. The 105 grease will not get everywhere, Just paint it on to get some lube everywhere. Doesn’t take much just a film of it on the splines.