Reply To: How to’s

[outsider]

Silicone works well too, even the high heat version on exhaust cover bolts so does ‘Form a Gasket’. they both seem to hold up well in salt running. Grease can be lightly put on 1 side of gaskets to ease disassembly. You can back small screws out with an Impact driver too, just have to be careful on the trigger. Working with a Makita drill driver kit I use both. The reason I specified the drill is far more options for even the lightest need because you can adjust it so low it couldn’t snap a #4 screw but can rattle it. The driver I have socket adapters so use it for the typical 7/16 etc. they make quick work of disassembly. More recently I got a Dewald driver. It’s got 3 options, the low is light enough to get the small screws, Mid about the same as the Makita & Hi, just short of lug nut, can break stuff.