Home › Forum › Ask A Member › Johnson PO-15 tiller witing › Re: Johnson PO-15 tiller witing
It’s been a long time since I wired a PO15 tiller, but going from memory.. One wire goes to the points terminal under the flywheel, then down to one end of the 2 prong connector. Now on the tiller side connector, one of the wires from the stop switch goes to the matching terminal of the same wire that goes up to the points terminal [under flywheel]. Now the remaining wire that comes from the stop switch goes through the remaining terminal on the 2 prong plug and then to a ground screw on the tiller bracket.
When the stop button is depressed the points terminal is grounded via the switch. Does this make any sense? Since there is only one set of points, there is only one wire going to the mag plate.