Reply To: Elgin 1.25 prop shaft seal

Home › Forum › Ask A Member › Elgin 1.25 prop shaft seal › Reply To: Elgin 1.25 prop shaft seal

April 29, 2021 at 6:29 am #237369
BRIAN RUPP
Participant
    Buccaneer wrote:

    11 mm would probably work for the shaft size, but the OD seems to be a problem.
    Can the bore for the OD be altered?

    I had to do just that for a couple seals for my Neptune. Either the ID or the OD was available, but not both. Prop seal I had to bore the housing bigger. Crank pto side I had to step the crank .030″ to fit a seal. Time will tell if I chose wisely on the crank…..