Re: Tearing apart my new QD-15

[mr-asa]

Dan
I may take you up on that offer. Other than a handful of miscellaneous hard parts, I think I’m most likely going to need a full seal kit for the lower, a carb kit, and the gaskets you’d associate with pulling the powerhead from the tower.

The hard parts I know I’m going to need are all of the bolts required to attach the exhaust cover of the mid-unit to the powerhead (three of them snapped, motor might’ve started as a Michigan motor, but it didn’t end that way), and the parts listed in this pic. Not sure what you’d call the lower bolts, but the top is the shift linkage
http://i.imgur.com/v4983p9.jpg
If someone could post the pics of that section of the parts breakdown, as well as the powerhead, I’d appreciate it

I might find a couple others as I dig into it more.