Reply To: Impellers Sears McCullough 14.1

[Jim Kivi]

Follow up: I was able to get an impeller for $7 (Amazon: Impeller 47-F436065-2 18-8903 9-45004 Replacement for Chrysler Force Mercury Marine 9.9HP 15HP ) which has the same half inch shaft diameter. I took a hack saw blade, and carefully cut a groove for the keeper pin (opposite the impeller slot for the key which was not used). I put the old impeller on the second location which runs the sump drain. I fired it up, and it apparently is working. This impeller probably has vanes that are a little long, but with some grease, they did go into the housing. I will drag it down to the beach and go for an extended trial when the wind here in Baja permits. This impeller and three feet of new fuel line has this motor running again after a LONG sit in a local garage. Fortunately, it was fogged and drained before being stored. I am not especially attached to this motor, so if you are trying to get one running, this one is available cheap on the OR/CA line near Yreka.