Reply To: Too much fuel too fast

[robotmark]

OK – we finally had a stretch of warm weather and I was able to get out there and work on the engine. I removed the carb and disassembled it. The tiny little clip that holds the float pin in place was missing, so the pin had come loose and wouldn’t do its job. That certainly explains all the flooding! So I replaced that, put a new float and gaskets it and got it back all together nice and new. I replaced the fuel pump while I was at it because why not! But, while I was poking around I noticed that the collar is missing from my throttle control rod. There’s a bunch of wire wrapped around the pivot pin to keep the throttle control rod in place but that is definitely not a good long term solution. I can pick up a replacement collar and screw, but my official service manual doesn’t tell me how or where exactly to install it. Also, does the control rod slide in the pivot pin, or should that be tight? I’m not sure if I need to replace that as well.

Thanks folks!