Re: ’60s Johnson water pump – Freeze Damage

Home › Forum › Ask A Member › ’60s Johnson water pump – Freeze Damage › Re: ’60s Johnson water pump – Freeze Damage

December 13, 2015 at 2:54 am #28521
Casey Lynn
Participant

    US Member

    Try grinding it out a bit and using epoxy in there. It’s not a load bearing area so should be just fine.
    The area with the piece that came free I think I would again use epoxy without grinding and press the piece in place until dry. After that do your grinding and add an epoxy filler.
    Kinda’ looks like that engine came from Minnesota….