Re: Prop won’t turn, but the powerhead does

Home › Forum › Ask A Member › Prop won’t turn, but the powerhead does › Re: Prop won’t turn, but the powerhead does

December 12, 2015 at 10:57 pm #28503
jeff-register
Participant

    Oz,
    Never know where they might of ended up! I asked a few questions at Johns Old Merc site & I wasn’t in the correct "FrankenMerc section even though all my parts came from Mercury, Just in different motors now. I was swapping a Mk 55 powerhead only using a Mk 30 crank to build a 25% higher cu in Mk 30 under the hood item. Should of built a driveshaft & been good with a U-joint above the gearset. Sounds like this guy built a beast too using all OMC part numbers. I’m confused now!!
    Jeff