Reply To: To Hone or Not to Hone

Home › Forum › Ask A Member › To Hone or Not to Hone › Reply To: To Hone or Not to Hone

February 5, 2021 at 12:46 pm #229574
David Stanton
Participant

    US MEMBER PAY BY CHECK

    I have sometimes very briefly used a 3-stone hone with plenty of oil to see if any part of the cylinder is out of round on a well-used motor. The only one I found to have out of round surface was a 1976 20 Merc with mega-hours on it. After brief honing, you can see the places where the hone didn’t touch.
    Dave