Reply To: To Hone or Not to Hone

Home › Forum › Ask A Member › To Hone or Not to Hone › Reply To: To Hone or Not to Hone

February 4, 2021 at 2:57 pm #229497
rudderless
Participant

    Usually I run the hone lightly to check the witness marks. One can tell a lot about the bore with a quick spot with the hone.

    If ya don’t want to remove a lot of material use a copper fitting brush powered by a slow drill. Gives a real nice finish. I used a 2″ fitting brush on my 9.9/15hp.