Reply To: 1956 Scott Atwater 7.5 hp Bail-a-matic impeller install

[Buccaneer]

Mumbles, I seen some kits on Ebay that showed the liner as a separate part
from the housing, but I agree, I didn’t see liners listed separately anywhere,
and I’m not ready to spend $50 on the kit, just for a liner.

I’m warming up the garage, and will soon go out and “think” about it,
and see If I have anything to make a liner out of.

I researched impellers from AOMCI charts last night, and ordered a couple
of Sierra 18-3072. The OD of this one is 1/16″ larger OD than the Honda,
the “height” is .006 thinner, and the bore would have to be bored out .080.
Sounds like this one might be a possibility?

I’ll still think about liner for the Honda impellers, but the ordered impellers
will be a “back-up” plan for the current Bailer, and the other one
patiently awaiting revival.

Prepare to be boarded!