How did the Honda impeller feel going in, enough bend in the vanes? And did you have to pull the driveshaft out again to get the impeller on the pin?
This photo shows the tension on the impeller vanes better. Looks like enough to me,
but the proof will be in the pudding……. when I do the drill test in a bucket of water.
My 1/2″ drill is rather slow, so not sure how it will compare.
How many rpms does a Scott Atwater idle at???
Once I had the impeller in the pvc sleeve, I just slide it straight down over the
key was I had sitting in the flat. I did nothing to the drive shaft.
Prepare to be boarded!