Home › Forum › Ask A Member › Johnson HD-25 Float question › Reply To: Johnson HD-25 Float question
November 17, 2020 at 7:16 pm
#221089
The tillotson carburetor on the small Neptune motors used the screw and clip that you mention. Take a trip to your local hardware store and pick up some 1/8 inch hairpin clips. The clips will slide on the needle and rest in the groove that the clip was in. They fit pretty snug on the pin. I do not use the screw. I hated to put a hole in the float.
The clips cost 30 cents each, I picked up some yesterday.