Home › Forum › Ask A Member › Gift from my boss .. Lightwin › Reply To: Gift from my boss .. Lightwin
Back on it a little .. Hard to find time ..
I guess where I checked the secondary on the coils beforeI was not getting good contact on the pin inside. So rechecked and one coil was 3900 ohms and the other was 7100 ohms ..
So checked the plug wires . Top one zeroed 0.0 out and the bottom one I could not get reading OL .. Is there a standard plug wire set I can get with the plug boot molded in or will I need to make my own ..
I picked up the points and condenser set . I checked the condensers with an analog meter the old and new . They all read the same for the most part . The needle would jump then ease back to infinity.. If that sounds right ..