Here are the videos I promised to make with my southern accent explanation I hope it helps. Turns out my low speed adjustment screw is 1/2 turn out from barely seated that is where mine idles the best. I didn’t even see how far out my high speed screw was because you don’t have one on your carb. If your high speed jet is working correctly yours should start in the start position or faster position. If you have water in a cylinder or both cylinders it will not start. I hope this helps you figure it out. If it were mine and wouldn’t start I would pull it out of the water pull the spark plugs take a shop vacuum and suck any water out of the cylinders put spark plugs back in and see if it will start in the start position or higher if it does its getting water in one or both cylinders don’t let it run long like that it won’t be cooling and its hard on impeller especially if impeller has been dry for a while. I hope these videos help.
https://www.youtube.com/watch?v=M4S5LD_yEjk&feature=youtu.be
https://www.youtube.com/watch?v=mIATNjjqKMM&feature=youtu.be
Hope this helps,
Joe
https://SecreLocal.com - - No Verify - Anonymous Adult Dating -
