Reply To: 1951 4443 Evinrude Fleetwin 7.5

Home › Forum › Ask A Member › 1951 4443 Evinrude Fleetwin 7.5 › Reply To: 1951 4443 Evinrude Fleetwin 7.5

August 3, 2020 at 5:45 pm #210795
Goman
Participant

    From what I remember I put a dab of epoxy on top of the o-ring and slid it up the shaft. I couldn’t figure what else to do either.
    I don’t see it holding after prolong use. Maybe the other seals will keep the water out of your gear box?
    On the clutch rod lower seal I think I used a tad bit oversized o-ring and epoxied it down to ensure it held while putting it back together.
    Mine is a runner but I haven’t run it since I prettied it all up.
    Glen