Reply To: 1948 Gale Hiawatha 5HP

[NBD925]

Does anyone know if gaskets are available or do I have to make them? What is the best material for this situation?

I did run water through the head and it was clear.

I will check the prop holes tonight and report back.

I have an odd piece on the prop shaft and I’ll try to get a picture of the parts stacked up while I inspect the prop.

Does anyone have a good exploded parts picture or a real life picture of the parts stack in their motor?

Here is what I have from memory.
Cotter Pin
Prop Nut
Prop
(What is the removal process for the inner hub?)
Then I have a small green tube Like a rubber hose on the shaft.
Then a more ridgid spacer like piece
Finally the cover to the pump with the two screws and the seal.

I’ll take a picture of what I take off tonight.