Reply To: qd 13 Coil

Home › Forum › Ask A Member › qd 13 Coil › Reply To: qd 13 Coil

June 23, 2020 at 1:23 am #206495
Phil Budne
Participant

    US MEMBER PAY BY CHECK

    The “bosses” that you can use for coil alignment are the machined surfaces JUST under where the coil “heels” (metal ends) end up. I usually just fiddle around until the coils are level with the machined surfaces. But that won’t work if the coils have bad laminates.

    http://www.omc-boats.org
    http://www.aerocraft-boats.org