ohm meter testing this coil. I disconnected all wires from the points and grounds. The coil has 4 solder points. one on each side and two on the top. I see the plug wire so know that is part of secondary
what readings should i be getting? here is a picture . we could use it for orientation. the side solder points are not visible but can be called side left, side right. Other 2 can be top left and plug.
It also isn’t that obvious how this coil come off the armature plate. do you take the one side off and then the coil slides out? Hoping I don’t have to go that far if readings work out.
Thanks
Ralph
