Reply To: Mercury KE4 impeller help needed

Home › Forum › Ask A Member › Mercury KE4 impeller help needed › Reply To: Mercury KE4 impeller help needed

April 14, 2020 at 5:32 pm #200006
ROBERT LAFAYETTE
Participant

    US MEMBER PAY BY CHECK

    Sometimes a custom
    Tool is the only
    “Correct” solution!
    If I were going to
    Make a custom
    Tool I would
    Design one with
    Larger pin dia
    For the tough
    Jobs.

    You might try a
    Couple of heat
    Cooling cycles
    Using propane
    Torch before
    Attempting again.

    Good luck,

    Bob