Re: Bendix Eclipse TMD question

[rokitjon]

OK I’ve been thru all the information again and am seeing NO torque specs at all so will rely on my trusty Grunt Torque Lever. I think these nuts should get about half a grunt..maybe a bit less.Will run it up to operating temperature,let it cool down and then retorque.

All that’s left is installing a replacement gas tank elbow fitting (to carb) as it was missing.LUCKILY I found a proper replacement in the plumbing section of Lowes.It’ s a 1/4" brass elbow fitting.

Keep my fingers crossed that the magneto’s are good and the wires won’t present a problem as one of them is showing some dry rotting and cracks in the rubber jacket.