Home › Forum › Ask A Member › Impeller fab – if you had your druthers › Reply To: Impeller fab – if you had your druthers
March 14, 2020 at 5:18 pm
#197356
Hi again guys,
Fifty20ne, I see you found the article on thinning an impeller, it’s a lot easier to understand with pictures ! Here’s another site I’ve used for trying to cross over an impeller from a different manufacture. The nice thing about it is they give all the dimensions for their impellers making it a lot easier, well maybe not a lot easier as the dimensions are in metric 😆 ! Just adds a little challenge to the job !
Gary