Re: Bendix Eclipse TMD question

[rokitjon]

Hi lotec,
I have watched that video,it was pretty good but frustrating at the same time! When you opened the side cover you almost showed the part of the throttle lever where this wire attaches but not quite..

This connection is made by a screw which goes thru the lever and slide bracket but there is an insulated collar which indexes the bracket and lever so that no contact is made if the lever is slid all the way down..

There is no place that looks like a kill switch was mounted on this motor.The tiller handle does not have any threaded holes,etc.

I need to figure out how to upload a picture,that would make this a lot easier!