Reply To: clinton K200 1106A

[Michael Purpura]

Tubs,
I cleaned the points, plug, I noticed that the plug wire was badly cracked. I found a coil and put it in. spun the flywheel, no spark. Next I am putting in a condenser. I do not know how to check the coil for continuity. I read that a multi meter attached to the coil and set to ohms should show a needle movement to the right. Then when the polarity is reversed show a movement to the left, in other words charge -discharge. But beyond that I don’t know how to check a coil. I have not put in the condenser yet. When I do I will see if I have spark. There is not much else to do. I found a carb kit so I plan to clean up the fuel bowl and rebuild the carb. The engine has good compression. I have to take apart the lower end and grease it and see if there is an impeller. That is all I know about this little engine.
Mike