Reply To: Eismann coils

[Buccaneer]

I went ahead a while ago and installed the one converted coil on the
mag plate. I was able to attach the spark plug wire to the coil
as intended, and exit the mag plate out the original hole.
Flywheel had plenty of clearance over the coil. Therefore, I tried it out
and was very happy to see nice blue spark!
Guess I’ll go ahead and whittle down the other Eisemann laminate
in the next day or so.

As a footnote, I was going to install some Zonghong (sp?) coils
for the conversion, but decided on some Sierra “green” coils that
Tubs mentioned. The primary leads on the Zonghongnese coils
were too short. Also, their primary’s OHM reading was 1.3, and
.7 on the Sierra…… not sure if that would have been an issue or not.

Prepare to be boarded!