Reply To: ELTO G Carburetor Questions

Home › Forum › Ask A Member › ELTO G Carburetor Questions › Reply To: ELTO G Carburetor Questions

December 9, 2019 at 8:35 am #189048
RICHARD A. WHITE
Participant

    Lifetime Member

    Trying to remember how to word this so everyone will understand.
    This type of gasket one should try to make the inside hole just larger than the tap drill size for the threads.
    For example, if the threads are 1-14, then the hole should be 15/16 in diameter or just a touch bigger. This allows
    the gasket to “thread” onto the cover and give the most possible coverage area. Then as Tubs states, trim the outside edge to suit.

    http://www.richardsoutboardtools.com
    classicomctools@gmail.com