Reply To: screw and nut on MQ 9.5hp

[JACQUES]

thanks

I had not noticed that the MQ’s year 65 version had no side idle adjustment on the tiller handle …all my previous 9.5 have the round idle setting on the tiller

makes a lot of sense !! 🙂

same goes for the clicker on the mag plate

I hope this one runs ok because I see sand all over the innards in the lower cowl section …

but….found no sand in the carb 🙂

and engine turns over smoothly by hand no crunching noises or vibrations no rust in cyl ‘s

I have yet to check compression… maybe tomorrow

if ok I’ll chug along and try to restore this freebie MQ and flush out all the sand crap (winter project)

Joining AOMCI has priviledges 🙂