Reply To: 35 Sportfour plug wire orientation

[tinkerman]

Thanks for the comments and for the diagram Gary. What ever I did the last time worked!! Needs some fine tuning but running well with no strange noises. Carburetors have always been my weak point but I feel like I’m starting to get a handle on it somewhat. My next project will be a 28 or 29 Fleetwin so I’m sure I’ll get some more practice! One more general question if anyone wants to educate me. The barrel I have for testing motors is pretty crude, just a plastic trash can. The water only comes about 4 inches above the impeller but on these old direct drive motors within 5 seconds of engine starting its rolled enough water out of the tank that it’s not covering the impeller so I’m NOT pumping water. I’m only starting and running for 15 seconds tops but I know this isn’t good. Is the only solution to get a bigger tank or are there some tricks to the trade. I wanna get to where I can tune the motors and smooth them out but with the situation I have I’m scared of getting the motor too hot. Thanks

It's a jungle out there.