Home › Forum › Ask A Member › Big Twin Lower Unit Reseal Question › Re: Big Twin Lower Unit Reseal Question
October 5, 2015 at 1:22 am
#25141
Im assuming it is leaking where it abuts the prop shaft seal housing carrier?
Ensure that the seal overhangs 1/16", not too short or it will shrink and leave a gap, not too long or it will buckle.
Before cutting it, ensure you push the seal to the outside edge of the groove.
The 847 is a superb product, not much better than that. If it is leaking, not the 847s fault, something else is going on.