Home › Forum › Ask A Member › TN 28 total rebuild › Reply To: TN 28 total rebuild
I was going over this tread again at I was reminded of a problem I had a few seasons ago. I was working on a motor that had water in it and was mildly stuck. A few smacks with a hammer and a block and it came apart. I decided to get some new rings and I fitted them to the cylinders. Did a lot of cleaning and some honing. When I went to assemble the pistons in their bores they were way to tight. I could barely move them up and down. After some rechecking I found that the ring locating pins had moved out some. (toward the cylinder) Maybe from ice, that moved the rings out and way to tight against the cylinder. Just a light smack with a punch and I moved the pins in a little and it cured my too tight problem! Something you can check when you get back into that motor.
dale