Reply To: How to : Evinrude Speeditwin ..

[Samuel Phelps]

We have a pulse gentleman. !!! 😋
After a crap load of reading and searching here I only found reference to the point setting at .012 , .015 , and .020 . So I set it at .015 . I picked up a set of the NKG -AB6 plugs . All I found was the gap should be .030 . They came preset at .025 so I just left it .. what should be the proper gap ?
I followed the starting instructions and read to really prime it good . A pull or two and it fired the backfired . I could get it to run for a few seconds but it would backfire and shut off ..
I think I should install the tiller handle for now till I get it running better and get used to it .
What should I be doing to stop the backfire and keep it running ?
Even though it only ran a few seconds I am pretty stoked about it !