Re: 7.5hp Cranks OMC

Home › Forum › Ask A Member › 7.5hp Cranks OMC (Edited Journal Clearances) › Re: 7.5hp Cranks OMC

September 30, 2015 at 11:48 pm #24944
chris-p
Participant

    All my rods are a bust.

    After polishing out the flaws, they measure about 0.8111 to 0.8115

    The spec in the manual is 0.8120 to 0.8125

    Too bad, cause they look shiny! 😉

    In fact, the best measurement I could get on any of them was 0.8120. But that was only on 1 of the 4 journals.

    Anyone have a good crank they can measure? Im curious if 0.8120 was factory. What is normal wear after this many years?