Re: OMC Binnacle/verticle control schematics/instructions/manual

[DAN ANDERSON]

OK, if it has that type of ignition switch we know it is 1996 or later (SystemCheck). You told me BRP so that was a no brainer! I have looked at all of BRP single binnacle boxes and they have the same BLACK button just behind the handle on the box mounting bezel. It’s about 3/4" square. In neutral you press it down and advance the lever to advance the throttle only. When you bring the lever back to neutral the button will pop up and you are ready to shift then again as normal. The handle can be put on in any position and you must find neutral before the button can be pushed to disengaged the box from shifting. You may have it out of sync if you haven’t mounted it yet?
While we are at it, I want to clear up any confusion anyone has over this type kill lanyard this motor uses. From 1996 forward OMC/BRP use a mechanical kill switch. That means all the device does is turn the key off. Once the lanyard is pulled off you can restart the motor if need be and continue on. Before OMC had an electrical kill switch that grounded the ignition system with a switch activated when the lanyard was pulled off a button switch. Some boat manufacturers still install that switch today, but most are just the mechanical type. They simple turn the key off when activated.

Dan in TN