I received my drain plug tube installation kit today,
and so far made the one (blue) "Fitted Flange Fixture"
on the lathe with a radius that fits the pre-flared
end of the tube.
Instruction card shows the other (blue) "Sloped Flange Fixture"
with a healthy bevel.
The store bought flaring tool appears in photos to show both
flange fixtures formed the same.
Do you think the fitting that’s going to flare the end of the tube
can be made the same as the "pre-flared" end?
It comes with an O-ring, but should I use a little
marine silicone for good luck?
Thanks.
Attachments:
Prepare to be boarded!