Reply To: EVINRUDE trigger coil

Home › Forum › Ask A Member › EVINRUDE trigger coil › Reply To: EVINRUDE trigger coil

March 16, 2019 at 12:52 pm #171272
Rick Robbins
Participant

    It was given to me and was told it was fine. When I initially checked the spark (using a neon plug tester) I had spark on cyl 2. Cyl 1 plug wire was missing the coil end connector in the wire cap. Replaced that but then had no spark on any cyl. It’s an OMC factory manual.

    Maybe I should get one of the Amphenol plug wire removal tools before I go any further.

    I’ll get back to it on Mon or Tues and send manual page pictures at that time.

    Thanks again for digging into this for me, sounds like I might have led myself astray by comparing the two different sensor readings.