Re: Johnson K50 weird shear pin diameter? Crash Video!

Home › Forum › Ask A Member › Johnson K50 weird shear pin diameter? Crash Video! › Re: Johnson K50 weird shear pin diameter? Crash Video!

September 21, 2015 at 1:38 pm #24312
clockguy2
Participant

    Since 3/16" (.1875") is so close to .182" , I would drill the prop shaft to fit common 3/16 brass rod. If you are not wanting to take the plunge, you could turn some 3/16 rod down in a lathe or chuck up a short length in a drill and sand or file to size while the stock rotates.