Home › Forum › Ask A Member › 60° looper starter stops cranking › Reply To: 60° looper starter stops cranking
February 11, 2019 at 10:19 am
#166622
Yes Frank, it happens when I test compression with all plugs out except for the cylinder I have the testing gauge plugged into. With all plugs out, this does not happen. I’ll give it a try with all plugs in too and report back.
The odd thing is I ran a compression test in this manner and it worked fine. I pulled the motor apart to replace a single rod/piston/rings, and then this issue arose.
I have seen this happen with other motors before when trying to start them, and they were all the same 60° looper design. Perhaps just a coincidence…