Re: Johnson HA-15 Carb Primer Pump

Home › Forum › Ask A Member › Johnson HA-15 Carb Primer Pump › Re: Johnson HA-15 Carb Primer Pump

September 14, 2015 at 10:35 am #23832
steveh
Participant

    Will,

    Been there and done that with an HD-25 carb. The PO had hammered the brass sleeve into place and it was oval instead of round. No amount of heat/lubrication would get that sucker out; had to drill it out.

    Doug Penn will have the brass washers/screws. http://penn.itgo.com/

    Good Luck!

    Steve.