Re: Early QD Carb Float

Home › Forum › Ask A Member › Early QD Carb Float › Re: Early QD Carb Float

September 14, 2015 at 4:18 am #23822
Leon
Participant
    quote Chris_P:

    I had thought of that Frank….I could not find any in my stash with the correct amount of width. I found one with too large an OD that I could sand down, but couldn’t get it flush with the carb casting as it was not wide enough…..wasn’t sure how to overcome that with the original hinge.

    How about trimming one down from a 5.5/7/5?