Home › Forum › Ask A Member › Carb plugs › Re: Carb plugs
Agreed, I don’t think I’ve ever found any debris under the welsh plug either. I do normally remove and check it anyway, just out of habit. Originally Gasoila sealer was used in sealing that area. It’s good stuff, but expensive and has a short shelf life. I’m not sure it’s even available anymore. If the plug is installed properly, you won’t need any sealer. But again out of habit I use a tiny amount of Jb Weld around the top edge of the plug after it’s installed. If you need to remove it, the JB will come loose with the old welsh plug. I use a 3/16 drill bit to carefully gain access, then use a round pin punch to pry it out. Be careful you don’t damage the carb body with the drill. Take your time.