Re: The high speed jet gasket question … again

Home › Forum › Ask A Member › The high speed jet gasket question … again › Re: The high speed jet gasket question … again

August 31, 2015 at 11:52 pm #22993
Don
Participant

    US Member

    I’m with you Joe, I don’t see how these carbs don’t slop over and run rich at high speeds. I don’t know how much clearance there is between the carb bowl nozzle well and the carb casting, but I don’t see how you could go wrong trying to fit some sort of oring/nozzle gasket seal in there.