Home › Forum › Ask A Member › Opposed Twin Coil swap….TG and others… › Re: Opposed Twin Coil swap….TG and others…
March 11, 2015 at 3:08 pm
#11815
quote Buccaneer:
I replied to this post last night, but I don’t see it. Is there a delay
or message approval in the system?
Anyway, Great write-up Richard!
Just one question…… “Why not shine up the laminations?”,
instead of just lightly buffing the ends?
Thanks, TG
or message approval in the system?
Anyway, Great write-up Richard!
Just one question…… “Why not shine up the laminations?”,
instead of just lightly buffing the ends?
Thanks, TG
The buffing of the ends is to allow them to "mesh" easier when putting the 2 halves together. My thought was that if I said clean them off one might interpret that as remove all residue, which might remove the coating on the metal. Does that matter??? I don’t know, but to me laminated metal is the base metal laminated between coatings of some sort. I was trying to avoid removing that coating.
http://www.richardsoutboardtools.com
classicomctools@gmail.com