Home › Forum › Ask A Member › Not an antique, but I need some help. › Re: Not an antique, but I need some help.
July 31, 2015 at 12:23 am
#21293
It was part of assembly 33. I replaced both the needle and seat, and hooked the small wire clip on the new needle to the float arm. It seems like everything is pointing to "I screwed something up" when I rebuilt the carb. I guess I will look that over again. Everything else on the motor points to it should run good. I will also look over the fuel lines for air leaks as well as the carb shaft bushings. Anyone else ever deal with this? You have a motor that seems like everything is right and it just kicks your butt?