Re: Phelon coils Mercury

[jasonh]

I didn’t give instructions rather a description of general process. I offered to dig up the detailed instructions. You never asked.

Basic troubleshooting needs to apply here. I have never had issues.

When I do it, I file even amounts off each side of laminate leg.

Did you use new plug wires and good condensers? Did you wire to correct points? Phelon laminates need to be mounted were originally mounted. Can’t swap them around. They were mounted then machined for proper air gap at factory. Besides that, tough to troubleshoot over internet. I assume if you are willing to take on conversion you are comfortable with ignition systems. You need to go down line and troubleshoot. Sounds like you used unknown coils. Verifying coil seems logical.